Fracture is an important parameter when you compare Adamite and Topaz Physical Properties. It is necessary to understand the significance of these properties, before you compare Adamite Vs Topaz fracture. Whenever a gemstone chip breaks, it leaves a characteristic line along its breakage. Such lines are known as fracture and are used to identify the gemstones in their initial stages of production when they are in the form of rough minerals. Fracture is usually described with the terms “fibrous” and “splintery” to denote a fracture that usually leaves elongated and sharp edges. Fracture observed in Adamite is Uneven, Subconchoidal and Conchoidal. Topaz fracture is Subconchoidal, Uneven and Conchoidal.
A primary knowledge about Adamite vs Topaz luster is useful in apparent identifications of these gemstones. Luster is the measure of light that gets reflected when incident on a finished cut gemstone. There are two major types of lusters: Silky and Adamantine. Since luster varies between two crystals of even the same gemstone, luster is limited to basic identification criteria. Adamite exhibits Vitreous luster. Topaz, on other hand, exhibits Vitreous luster.